10FOUR Instant Consistency Math + Promo Code COMPARE

For 10FOUR Instant Prime, reaching a cycle's stated profit goal is not sufficient when the largest winning day exceeds the selected consistency percentage. For the documented 20% and 25% versions, compare the ordinary cycle goal with the largest day divided by the percentage. The larger amount is the minimum total profit needed for those two tests, assuming all other eligibility conditions are met.

Code: COMPARE

Use verified code COMPARE for 40% off eligible 10FOUR futures account purchases. The verified $50K Instant 20% configuration has a $490 regular fee, producing a calculated $294 base purchase price and $196 saving. Do not apply that price to another consistency selection.

Checked 9 October 2026. This guide covers the 20% and 25% versions described in the official Instant Prime payout article. The public selector also advertises a 15% option; its complete payout terms are outside this article's verified scope.

Identify the purchased percentage first

The official Instant Prime payout objectives distinguish 20% and 25% consistency, with the 25% version available only at $25K and $50K. The rule compares the largest winning day with total cycle profit and resets after an approved payout.

For the $50K tier, the article lists a $3,000 first-cycle profit goal and $2,500 for later cycles. It also lists a $500 minimum request and separate request caps. These are separate gates, so “profit needed to qualify” and “money available to request” should occupy different cells in a tracker.

Save the actual order's account selection and the account's current terms. A guide for another percentage, an older account description or a generic Instant headline cannot establish which denominator applies to a particular purchase.

Use two calculations, then take the larger amount

Let B be the largest winning day in the current payout cycle, C the selected consistency percentage as a decimal, and G the applicable cycle profit goal.

The consistency calculation is B divided by C. The combined mathematical requirement is the greater of G and B divided by C. Round any calculated threshold upward to a usable cent when necessary; rounding down can leave the best-day percentage fractionally too high.

These formulas address only the stated profit and consistency tests. They do not establish compliance with maximum loss, daily loss, execution restrictions or account review requirements. A spreadsheet result is a planning aid, not the firm's payout decision.

Example: the same $800 day produces different totals

Assume a first $50K cycle with an $800 best day:

At exactly $3,000 total profit, $800 represents about 26.67%, so neither version passes its consistency test in this hypothetical sequence. The difference between the two calculated thresholds is $800. That is extra qualifying profit required under the narrower percentage, not a fee, penalty or promised trading outcome.

Notice that the account cannot qualify merely by accumulating more trading days with no additional net profit. The percentage uses a profit denominator. Conversely, a later losing day can reduce the denominator while leaving the earlier best day unchanged.

Example: the published goal still matters

With a $500 best day on a first $50K cycle, the 20% calculation gives $2,500 and the 25% calculation gives $2,000. Both are below the $3,000 first-cycle goal. The ordinary goal is therefore the binding test in this example.

This is why a formula should use the greater of the two amounts. A tracker that shows only best day divided by the percentage can understate the requirement. A tracker that shows only the plan goal can understate it in the opposite situation.

Start a new ledger after an approved payout

Use a separate cycle identifier, start date, net cycle profit and largest day for each payout cycle. Do not let the previous cycle's largest day or accumulated total leak into the next calculation. Keep the account balance in another column because retained account profit and new cycle profit are different concepts.

For illustration, suppose the next $50K cycle has a $600 best day and a $2,500 ordinary goal. At 20%, the consistency calculation is $3,000; at 25%, it is $2,400. The combined thresholds are $3,000 and $2,500 respectively. Reusing the first-cycle $3,000 goal would hide the second result; reusing an earlier best day could distort both.

If a payout is pending, record its status explicitly. The official policy warns that trading before processing can reduce eligibility and says submitted requests cannot be edited or canceled. Avoid marking a new cycle as approved merely because a request button was clicked.

Check the requested amount separately

The payout article lists a 90% trader share, a $2,000 request maximum for the first three $50K payouts and $2,500 for payouts four through six. A $4,000 qualifying-profit calculation does not authorize a $4,000 request. Other conditions, available balance and firm approval remain relevant.

A useful tracker therefore has four different outputs: total qualifying profit needed, present profit gap, permitted request after all account checks, and estimated trader share. Combining these into one “payout” number invites an avoidable error. Label an estimate as an estimate and reconcile it with the dashboard before submitting.

Purchase pricing for the verified 20% version

The official 10FOUR homepage displayed the following 20% configuration during this review. The active COMPARE offer supplies the 40% rate. Prices are in USD.

The arithmetic is $490 multiplied by 0.60. This is an eligible base-fee calculation, not a completed checkout test. Other percentage choices are separately priced. Taxes, payment charges, resets and optional purchases are excluded, and no public sale is stacked with COMPARE.

Other rules can still prevent a request

10FOUR's permitted-activities policy restricts Instant trading within five minutes before or after flagged news events. It also requires scalping to comply with the separate execution policy. Passing a consistency calculation does not establish that every trade was permitted.

Before buying, consult the 10FOUR firm page for the wider program and the household-account guide before adding another account. Choose the rules your existing process can follow, and compare the complete account terms rather than assuming a looser consistency percentage guarantees an easier or faster payout.

How to use COMPARE

1. Open the official account page and choose the exact plan, size and available configuration.
2. Enter COMPARE in the coupon field before paying and apply it.
3. Review the eligible base fee, applied discount and complete total, including any separate charges or later payments.
4. Confirm the account rules and save the receipt and selected program terms.

Affiliate disclosure: Compare Futures Prop may earn a commission through links or codes. Program qualification and performance rewards depend on the applicable rules and are not guaranteed.